Roborock forum
Roborock Points
How to earn Roborock Points
  • 1、New users: 100 points (Newly registered accounts only)
  • 2、Sign in /per week : 1 point (Once per week)
  • Message our official RR_Deal account for more details（ All rights of explaination are reserved by Roborock）
search
Get Roborock Points+5
Roborock forum

S6 dustbin sensor

Kelly 844 9 0

S6 dustbin sensor

Kelly 844 9 0

Due to a problem with my fish tank, the floor got wet and my S6 got some water in it. This has caused the dustbin sensor to fail. I have one on order but want to know how to bypass it so I can use the vacuum in the meantime. Can I jump a couple wires? Or do have to install a resistor? With how much it takes to get to the sensor I don’t want to do trial and error.

0
0
You can share this article on the community website!


  • RR_SupportStaff Member

    Hello,

    What do you mean by refer to dust bin sensor? You can send us a picture for reference.


    Also, you can set no go zone around the fish tank, then the robot won't go there anymore.

    Like0
    Reply
    Kelly
    Kelly01/10/2021      15:29
    @RR_Support:


    Like0
    Reply
    Kelly
    Kelly01/10/2021      15:31
    @RR_Support:

    These are for dustbin and water tank. Both were damaged from water.

    Like0
    Reply
    RR_Support
    RR_SupportStaff Member01/11/2021      08:49
    @Kelly:

    Did you disassemble the device?

    Could you send us the serial number of the S6?

    Like0
    Reply
    Load More >>

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Sign In Register
Kelly
Welcome to Roborock Forum